Silicone watch strap keeper, emerald green, for 18 mm straps
This 18 mm watch strap loop in emerald green silicone keeps the tail of your strap flat against the band once the…
passant-18-18This brown silicone keeper is sized for 14 mm watch straps, with an inner width that matches the strap itself. Measure the strap across, near the lugs or at the old keeper, and pick the same figure, here 14 mm. A quick wash in soapy water is all it needs to stay clean. Brown keeps a traditional look and blends with wood and leather tones.
Brown silicone is often chosen by people who like the warmth of a leather strap but need something that tolerates water. If your watch wears a brown rubber band of 14 mm, this keeper will match it and keep the end of the strap pressed neatly against the rest of the band.
The colour also suits watches with gold, bronze or rose-gold cases, cream dials and vintage styling. On a beige or tan strap it gives a gentle tone-on-tone effect, and next to green or khaki it reinforces an outdoor look.
Straps usually outlive their keepers. The loop is pushed and pulled every time the watch goes on, and eventually it cracks or loosens. Swapping in a new ring brings back the tidy finish at little effort, without changing a strap that still fits well.
Fitting needs no tools: the silicone stretches just enough to go over the strap tip, then grips the band once in place. Water, sweat and humidity do not harm it, and washing with warm, soapy water keeps it clean.
Check the strap width beforehand. Measured across the band near the buckle, it should be 14 mm.
Can a brown silicone keeper go on a brown leather strap? Yes, if the strap is 14 mm wide; the look is slightly different because silicone has a smoother, more matte surface than leather.
Will the brown colour fade in the sun? Silicone holds its colour well under normal wear; rinsing off sun cream helps it stay even.
Data sheet