Khaki silicone watch strap loop for 22 mm straps
Has the keeper on your 22 mm strap snapped? This khaki silicone replacement restores a tidy finish. It suits classic…
passant-22-20Keep your strap end under control with this yellow silicone keeper, made for 22 mm watch bands. Bright yellow matches a yellow strap or stands out against black and navy. The silicone stretches slightly, so you can ease it over the strap without tools or any watchmaking know-how. To choose the right size, measure your strap where the loop sits: it should read 22 mm.
Yellow straps are bold by design, so the keeper on them should be bold too. This loop is a bright, clean yellow, the kind of shade found on adventure watches, sailing chronographs and colourful sports models.
A strap often outlives its loop. The ring gets snagged, splits along one side or simply stretches until it no longer grips. Swapping only the keeper costs far less effort than hunting for a new yellow strap, and the band looks whole again.
On a yellow strap it matches. On black it creates the classic high-visibility combination seen on many tool watches, and on navy or grey it brings a cheerful highlight that echoes a yellow seconds hand or a yellow dial index.
Fit is for straps exactly 22 mm wide. Measure across the band where the loop rides, after the buckle, with a millimetre ruler. Silicone stretches to pass over the strap end, then grips gently.
Lighter colours can show dirt more readily; a quick wash in warm water with a little soap brings yellow back to its full brightness. Water and perspiration do not damage the material.
Will yellow fade in the sun? Silicone holds its colour well in normal daily wear; keeping it clean helps it stay vivid.
Can a 22 mm keeper go on a 20 mm strap? It would be too loose and slide around. Choose the size that matches your strap width.
Data sheet